4-way CT Block
Manufactured from Epoxy Resin with four brass Inserts with M6 thread on each end, and two chamfered holes to allow it to be bolted down to the tank.
It is required to use the correct amount of nuts and washers to suit the correct number of CT terminals being used.
Tighten nuts to 2lbs/ft of torque using a calibrated torque wrench.
 4 Way CT Terminal Block Test
The terminal block shall be air pressure leak tested at 1 bar for 15 minutes, where there should be no signs of air leakage.
Parts are identified with a unique identification serial number with full traceability to materials used and date of manufacture.
|
